Description

AZDENT Dental Wireless LED Plus 105 Cure Light Lamp 1 Second Curing High Power Wide Spectrum 2500 mw/cm² Dentist Instrument

The LED Plus model is a 90-degree, 105-degree Angle with 8 watts. Use 3 blue light plus 1 purple light high-power chip. The effect of light can be seen that the light transmittance of the light cross lens reaches 97%. It is more convenient to light solidify the molars inside the mouth.

INSTALLATION:

• Insert light head into the curing light handpiece with a twisting motion，Ensure that both the direct light source head and the light curing host are fully connected to their corresponding positions

• Connect the adapter connector to the USB Type-C charging line, and then connect the power supply. The magnet tail cap at the bottom of the host can be stably adsorbed on other metal surfaces.

• After switching on the power adapter, insert the charging port or pull out the charging port, the machine will wake up automatically, and the host screen will light up

• The main panel indicator light "orange" indicates that the battery is in charge, and the light "green" indicates that the battery is full, and the machine will automatically stop charging.

• When the host is charged for one minute in an unused state, the screen will shut down automatically, and the battery will still be charged until the battery is full。

• The battery is not fully charged prior to shipment. Please charge the battery for a minimum of 4 hours prior to first use。

• To check the battery, press and hold the time switch for 4 seconds, display screen will show:

   a.) 4.2 – 3.7- Battery is normal

   b.) Lo- Battery is low

• When battery is low, curing light circuit will automatically compensate for power output or turn the light off. Always recharge the curing light when the battery is low Lo

• Direct charging option from transformer for easy transportation and mobility

OPERATION:

• Turn on the curing light with on/off switch

• his machine has 1S high power. 3S high power. full RAMP PULSE 3'+3'+6'+6'seven working modes. The default  mode is (full power) and the default time is 10 seconds.

• Press and hold the time button for 0.1 seconds to select the time.Only three time modes of FULL RAMP PULSE can be selected, which are 05 10 15 20 25, respectively.  

• Long press mode button 0.5 seconds to unlock, mode selection can be made, when no operation 30S automatically unlock, and long press mode button 0.5 seconds to unlock.

• Every change of time or mode, there will be a ‘beep’ sound. The curing light will keep the last program selected in memory

• Put on the disposable curing light sleeve to cover the whole curing light for cross-infection control. Then put on the light protective shield and light head protective ring, the curing light is ready for use

• Remove and dispose of the curing light sleeves after every patient

• Curing light will automatically turn off if not in use for 1 minute

SPECIFICATION:

Power supply:Input:AC 100-240V, 50/60Hz  

Output :DC 5V/1A

Intensity High: 2500 mw/cm²

Battery:3.6V, 2600 mAh (9.36Wh)

Handpiece dimension:Φ3.0 cm x 24 cm .

Packing List:

Main unit of the LED x1

Protective light shieldx1

Transformer (100 -240V)x1

USB Type-C Chrging linex1

Instruction manual x1